Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
- 10. Brake system
   10.2. Technical characteristics
   10.3. ABS system
   10.4. Blocks of disk brakes
   10.5. Brake support
   10.6. Brake disk
   10.7. Blocks of drum-type brakes
   10.8. Wheel cylinder of brakes
   10.9. Main cylinder of brakes
   10.10. Hoses and hydraulic actuator tubes
   10.11. Air removal from a hydraulic actuator of brakes
   10.12. Vacuum amplifier of brakes
   10.13. Blocks of the parking brake of back disk brakes
   10.14. Parking brake
   10.15. Cables of the parking brake
   10.16. Switch of a signal of braking
   10.17. ABS: natural choice
   10.18. Malfunctions of brake system
+ 11. Body
+ 12. Electric equipment


10.16. Switch of a signal of braking
GENERAL INFORMATION

Switch of a signal of braking

1. Pedal height


2. Pusher


3. Switch of a signal of braking

The switch of a signal of braking is mounted on an arm near the top part of a pedal.

Removal and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight, disconnect from the switch of a signal of braking the conducting socket.
2. Release a lock-nut and turn out the switch from an arm.
3. Installation is carried out upside-down.

Adjustment

PERFORMANCE ORDER
1. Check and if necessary adjust pedal height. See subsection 2.23.
2. Release a lock-nut and rotate the switch so that the vystupaniye of a plunzher And corresponded to norm (see subsection 10.2.). If to check a vystupaniye it is impossible, adjust position of the switch so that the plunzher slightly concerned the limiter of a pedal of a brake. Tighten a lock-nut.
3. Attach wires to the switch, connect the battery to weight. Check operation of the switch. Signals of braking should light up by pressing a pedal and die away at a pedal otpuskaniye. Otherwise repeat adjustment.
4. Check and if necessary adjust a free wheeling of a pedal. See subsection 2.23.