Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
- 3. Engines
   - 3.1.2. Compression check
      3.1.3. Top dead point (VMT) of the N1 piston
      3.1.4. Cover of a head of cylinders
      3.1.5. Inlet collector
      3.1.6. Final collector
      3.1.7. Gas-distributing belt and asterisks
      3.1.8. Forward epiploon of a cranked shaft
      3.1.9. Camshaft epiploon
      3.1.10. Camshafts and lifts of valves
      3.1.11. Head of cylinders
      3.1.12. Oil pallet
      3.1.13. Oil pump
      3.1.14. Flywheel / leader disk
      3.1.15. Back epiploon of a cranked shaft
      3.1.16. Engine fastenings
   + 3.2. 6-cylinder dvukhryadny engines of V6 3,0 l
   + 3.3. Partition of engines
   + 3.4. Engine electric equipment
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
+ 9. Running gear
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


3.1.3. Top dead point (VMT) of the N1 piston
GENERAL INFORMATION

The highest point of which reaches the N1 piston at the moment of a compression step is accepted to the top dead point.

The N1 piston is located in a forward part of the right number of cylinders from a gas-distributing belt.

PERFORMANCE ORDER
1. Disconnect a wire of the minus plug of the accumulator and if necessary unscrew spark plugs.
2. Remove an external cover of a gas-distributing belt.
3. Turn a cranked shaft so that sinkhronizatsionny labels of asterisks of camshafts were directed up and combined with cuts in a cover of a gas-distributing belt. On each asterisk there are two labels (see the table of the Label of a camshaft).
4. Combine a label on a pulley of a cranked shaft (shooter) with the index on a casing of the oil pump. When labels are combined, the N1 piston is in VMT at the moment of a compression step.

Camshaft labels

CAMSHAFT
LABEL WHICH IS NECESSARY FOR USING
Final valves of the right head of cylinders
1
Inlet valves of the right head of cylinders
2
Inlet valves of the left head of cylinders
3
Final valves of the left head of cylinders
4