Toyota Camry

1996-2001 of release

Repair and car operation


Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
   - 9.1.2. Technical characteristics
      9.1.3. Stabilizer of cross-section stability of a forward suspension bracket
      9.1.4. Rack of a forward suspension bracket
      9.1.5. Rack and suspension bracket spring
      9.1.6. Suspension bracket lever
      9.1.7. Spherical support
      9.1.8. Rotary fist and nave
      9.1.9. Nave and bearing of a forward wheel
      9.1.10. Stabilizer and plugs of the stabilizer of a back suspension bracket
      9.1.11. Rack of a back suspension bracket
      9.1.12. Longitudinal bar
      9.1.13. Levers of a back suspension bracket
      9.1.14. Nave and bearing of a back wheel
      9.1.15. Arm of a back suspension bracket
      9.1.16. Corners of installation of wheels
   + 9.2. Steering
   + 9.3. Semi-axes
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment


9.1.3. Stabilizer of cross-section stability of a forward suspension bracket

Installation

PERFORMANCE ORDER
1. Lift a forward part of the car and establish on supports. Remove forward wheels.
2. Remove the panel of protection of a wing which fastens three bolts.
3. Disconnect steering drafts from the left and right rotary fists (see subsection 9.2.3.).
4. Disconnect drafts of the stabilizer from a bar, having unscrewed nuts (arrow). At a provorachivaniye of a hairpin fix it a six-sided key. At removal of the lever unscrew the bottom nut.
5. Unscrew bolts of fastening of collars of plugs of the stabilizer to an engine frame.
6. Remove forward section of an exhaust pipe.
7. Unscrew bolts of fastening of the steering mechanism (see subsection 9.2.5.).
8. Remove the steering mechanism and get a stabilizer bar from the left wheel.

9. Remove rubber plugs and check their condition. If on plugs damages are found, replace plugs. Check a condition of hinges of drafts of the stabilizer for what shake 5–6 times the spherical hinge here and there. Then screw a nut and turn it a dinamometrichesky key (with a scale in some N of m) on 1 turn, doing a turn during 2–4 seconds. At commission of the 5th turn read the instrument of a dynamometer of a key which should be in limits from 0,04 to 0,87 N of m. Otherwise draft of the stabilizer replace.
10. Clear a place of a prileganiye of plugs on a bar of dirt and a rust.

Installation

PERFORMANCE ORDER
1. Grease new plugs with culinary vegetable oil.
Prevention

It is forbidden to grease plugs at assembly by mineral oil, oil on an oil basis, or brake liquid in order to avoid a premature exit of plugs out of operation.
2. The stabilizer is established upside-down.