Toyota Camry

1996-2001 of release

Repair and car operation

Kamri's Toyota
+ 1. Maintenance instruction
+ 1.2. Information before car driving
+ 1.3. Independent maintenance
+ 1.4. Technical characteristics
+ 1.5. Some councils upon car purchase
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Transmission
- 9. Running gear
   - 9.1.2. Technical characteristics
      9.1.3. Stabilizer of cross-section stability of a forward suspension bracket
      9.1.4. Rack of a forward suspension bracket
      9.1.5. Rack and suspension bracket spring
      9.1.6. Suspension bracket lever
      9.1.7. Spherical support
      9.1.8. Rotary fist and nave
      9.1.9. Nave and bearing of a forward wheel
      9.1.10. Stabilizer and plugs of the stabilizer of a back suspension bracket
      9.1.11. Rack of a back suspension bracket
      9.1.12. Longitudinal bar
      9.1.13. Levers of a back suspension bracket
      9.1.14. Nave and bearing of a back wheel
      9.1.15. Arm of a back suspension bracket
      9.1.16. Corners of installation of wheels
   + 9.2. Steering
   + 9.3. Semi-axes
+ 10. Brake system
+ 11. Body
+ 12. Electric equipment

9.1.8. Rotary fist and nave

Removal

PERFORMANCE ORDER

1. Release a nave nut (see subsection 9.1.14.). Release wheel nuts, lift the car and remove a wheel.
2. Remove a support of a brake and fix a wire (see subsection 10.5.). Remove a support arm, remove from a nave a brake disk.
3. Release (but do not turn on) bolts of fastening are resistant to a rotary fist.
4. Disconnect from a rotary fist a tip of steering draft (see subsection 9.2.3.).

5. Unscrew bolts and nuts of fastening of a spherical support to the bottom lever of a suspension bracket. Now unscrew bolts of fastening of a rack to a rotary fist.
6. To Vytolknita from a nave a semi-axis (see subsection 9.3.2.). Fix the semi-axis end.
7. Separate a rotary fist from a rack. If necessary remove a spherical support.

Installation

PERFORMANCE ORDER

1. Establish on places a rotary fist and a nave, insert a semi-axis.

2. Insert a rotary fist into a rack flange. Wrap nuts and bolts, but do not tighten.

3. Attach a spherical support to the bottom lever of a suspension bracket, wrap bolts and fastening nuts, without tightening them.

4. Attach to a rotary fist a tip of steering draft. Tighten bolts and nuts of fastening are resistant, fastenings of a spherical support to the lever and a nut of a tip of steering draft with the set moments.

5. Establish a brake support (see subsection 10.5.) and a brake disk (see subsection 10.6.).

6. Establish a nave, tighten a nut.

7. Establish a wheel and wrap nuts.

8. Lower the car, tighten wheel nuts with the set moment. Tighten a nave nut with the set moment.